Red Hat ENTERPRISE LINUX AS 2.1 - Przewodnik Instalacji Pobierz pdf (Strona 48)

40 Appendix B. Sample Parameter Files

To force a speciﬁc CTC protocol, additional parameters can be added. For example:

CTCPROT=<n>

where <n> is one of the following:

• 0 for compatibility mode (used with non-Linux peers other than S/390 and zSeries operating

systems)

• 1 for extended mode

• 2 for CTC-based tty (only supported on Linux-to-Linux connections)

• 3 for compatibility mode with S/390 and zSeries operating systems

PEERID=<userid>

Where <userid> represents the ID of the guest machines you want to connect to. Note that

the ID must be written in capital letters. For example, an IUCV connection to a z/VM TCP/IP

service machine would be written as:

PEERID=TCPIP

The following parameters are optional:

HOSTNAME=<string>

Where <string> is the hostname of the newly-installed Linux guest.

NETTYPE=<type>

Where <type> must be one of the following: ctc, iucv, qeth or lcs.

IPADDR=<IP>

Where <IP> is the IP address of the new Linux guest.

NETWORK=<network>

Where <network> is the address of your network.

NETMASK=<netmask>

Where <netmask> is the netmask.

BROADCAST=<broadcast>

Where <broadcast> is the broadcast address.

GATEWAY=<gw>

Where <gw> is either the gateway-IP for your eth device or the IP address of the ctc/escon/iucv

point-to-point partner.

MTU=<mtu>

Where <mtu> is the Maximum Transmission Unit (MTU) for this connection.

DNS=<server1>:<server2>:...:<serverN>

Where <server1>:<server2>:...:<serverN> is a list of DNS servers, separated by

colons. For example:

DNS=10.0.0.1:10.0.0.2

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 85 86

Brak uwag

Red Hat ENTERPRISE LINUX AS 2.1 - Przewodnik Instalacji Strona 48