Red Hat NETSCAPE ENTREPRISE SERVER 6.1 - INSTALLATION AND MIGRATION GUIDE Instrukcja Użytkownika Pobierz pdf (Strona 78)

Figure 47 - Create Adapter Screen

Give an adapter number that the sever will use to see the storage on. We have 34 in this

example.

Note: For best practices we try to assign adapters in a range to make things easier to

diagnose. So a typical setup may be to put all rootvg storage on adapters in the 20’s rang and

all data in the 30’s etc. For this example we will just assign in the 30’s range.

Another word here on the required for partition activation. This is not necessary to check at

this time. If assigned to the server it will be assigned at activation. When checked the client

server can boot unless the VIO server is up.

If we leave the radio button on the “Any client partition can connect “ Then this storage can

be assigned to any partition. Setting to “Only selected client partition can connect” will force

that single client partition can connect.

In the case where you don’t want to reboot the VIO server each time you add storage, you

would assign to any partition.

So just click OK on this window to take the default settings. You can create more adapters

if you want other storage available.

When you have created the adapters you want to add, select the OK button on the profile

window to save the profile.

Select Close on the Managed Profiles window.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 119 120

Brak uwag

Red Hat NETSCAPE ENTREPRISE SERVER 6.1 - INSTALLATION AND MIGRATION GUIDE Instrukcja Użytkownika Strona 78