
www.vmware.com
140
Guest Operating System Installation Guide
6. At the View/Edit Property Settings screen, use the arrow keys to navigate to ata-
dma-enabled, press Enter to select it, then press F3 to change the value.
7. At the Specify Value prompt, type 1 and press Enter to enable DMA.
8. When you return to the View/Edit Property Settings screen, press F2. Then on the
Boot Tasks screen, press F3.
9. Choose CD if you are installing from the CD-ROM set and continue with the
normal installation steps.
10. When the kdmconfig - Introduction screen appears, press F4 to skip
configuration of the X server for now.
Note: It is important to skip configuration of the X server both at this point and
at the point mentioned in the next step. Wait until the third opportunity — after
all the software is installed — before configuring the X server.
11. After the first reboot and before installing the Solaris software, the installer again
displays the kdmconfig - Introduction screen. Again, press F4 to skip
configuration of the X server for now.
12. After installing all the software and rebooting, the installer again displays the
kdmconfig - Introduction screen. This time, press F2 to continue with the
configuration steps.
13. Press F2 to configure the video device and monitor.
14. Press Enter to select 16 color Standard VGA 640x480 (256K), then press F2 to
continue.
15. Use the arrow keys to move to Multifrequency 100KHz (up to 1600x1200 @
80Hz), press Enter to select it, then press F2 to continue.
16. Keep the default screen size of 17 inches and press F2 to continue.
17. Keep the default of No changes needed – Test/Save and Exit. Press F2 to
continue.
18. Press F4 to bypass the tests.
19. Continue with the normal installation steps.
This completes basic installation of the Solaris 10 guest operating system.
Note: There is no VMware Tools package for Solaris guest operating systems.
Komentarze do niniejszej Instrukcji